External Automatic Antenna Tuner "Fc-30" Installation; Parts List - Yaesu FT-897D Operating Manual

Parts List

Screws (M3 x 6B) ........................................................ 2
Screws (M3 x 6B) ....................................................... 6
Mounting Plate A .............................................................. 1
Mounting Plate B .............................................................. 1
Mounting Plate C .............................................................. 1
Installation
1. Turn the transceiver's power off, and disconnect all
cables from the transceiver.
2. Screw the mounting plate "A" to the FC-30 using the
supplied screws (Figure 1).
3. Remove the four rubber lugs and their four screws (Fig-
ure 2), then position mounting plates "B" and "C" so
that their holes align with those on the FT-897D, and
secure using the supplied screws (Figure 3).
4. To install the FC-30, position the FC-30 so that the
mounting plate "A" on the side fits into the mounting
plate "B" on the FT-897D (Figure 3), then screw the
mounting plate "C" (on the FT-897D) to the FC-30 us-
ing the supplied screws (Figure 1).
See page 41 for connection of the FC-30/FT-897D and op-
erating procedure.
Do not install the supplied FC-30 Mounting Screws
if you are not installing the FC-30! Also, do not
use an improper screw for mounting the FC-30! An im-
proper screw may cause a "short circuit" to the internal
circuitry, causing serious damage!
Plate B
FT-897D O M
I
NSTALLATION OF
E A
Figure 3
O
PTIONAL
A T "FC-30"
Plate A
A
CCESSORIES
Plate B Plate C
Plate A
Figure 1
Figure 2
Plate C
Page 67