4
Under Trap Destination, type the IP address of the network management server or monitoring station, and then
click the check box next to each condition that should generate an alert.
5
Click Submit to save changes, or Reset Form to clear all fields.
Enabling the security reset jumper
The Security Reset Jumper is a hardware jumper located on the motherboard. Administrators can use the Embedded
Web Server to specify the effect of using this jumper.
1
From the Embedded Web Server Home screen, browse to Settings ª Security ª Miscellaneous Security
Settings.
2
From the Security Reset Jumper list , select No Effect (to remove access to all security menus—use with caution),
Access controls = "No security" (to remove security only from function access controls), or Reset factory
security defaults (to return all security settings to default values).
3
Click Submit to save the changes.
Warning—Potential Damage: If "No Effect" is chosen and the password (or other applicable credential) is lost, you
will not be able to access the security menus. To regain access to the security menus, a service call will be required
to replace the device RIP card (motherboard).
Using security features in the Embedded Web Server
28