Table of Contents
Advertisement
MAINTENANCE
STORAGE
Your mower represents an investment from which you should get the greatest possible benefit. Therefore,
when the season is over, the mower should be thoroughly checked and prepared for storage so that a
minimum amount of work will be required to put it back into operation for the next season. The following are
suggested storage procedures:
1. Thoroughly clean the mower.
2. Lubricate the cutter as covered in Maintenance Section.
3. Tighten all bolts and pins to the recommended torque.
4. Check the mower for worn or damaged parts. Make replacements immediately.
5. Store the mower in a clean, dry place with the mower head resting on blocks.
6. Use spray touch-up enamel where necessary to prevent rust and maintain the appearance of the mower.
PROPER TORQUE FOR FASTENERS
The chart lists the correct tightening torque for fasteners. When bolts are to be tightened or replaced, refer to
this chart to determine the grade of bolts and the proper torque except when specific torque values are
assigned in manual text.
RECOMMENDED TORQUE IN FOOT POUNDS UNLESS OTHERWISE STATED IN THE MANUAL*
NOTE: These values apply to fasteners as received from supplier, dry or when lubricated with normal engine
oil. They do not apply if special graphited or molydisulphide grease or other extreme pressure lubricants are
used. This applies to both UNF fine and UNC coarse threads.
VERSA PRO 03/09
Maintenance Section 5-24
© 2009 Alamo Group Inc.
Advertisement
Table of Contents
