Auto Ya; Delay - DigiTech RP14D User Manual

An Auto Ya is like the YaYa in sound in as much as it combines the characteristics of a wah and a flanger together. The difference is that the
Auto Ya provides animation to the sound automatically. The Auto Ya parameters are as follow:
Speed
Depth
Regeneration

Delay

Parameters
Type
Level *
Time
Feedback *
Delay is an effect that will record a portion of the incoming signal, and then play it back a short time later. It can repeat the recording
several times, or just once. This type of effect is also referred to as an echo because it basically echoes the original signal. Delay Parameters
are as follows:
Type
Level
Time
Feedback
*
Note: These Parameters can be assigned to the Expression Pedal. See page 11 for more information on Expression Pedal
assignments.
RP14 UserÕs Guide
a ya (Auto Ya)
Parameters Displayed Values
0 . . . 1 0 0
Speed *
0 . . . 1 0 0
Depth *
0 . . . . 40
Regeneration *
Determines the rate of sweep in the YaYa effect. Ranges from 0 to 100.
Controls the intensity of the YaYa effect. Ranges from 0 to 100.
Controls the throaty quality of the YaYa. Ranges from 0 to 40.
Displayed Values
dig, dp n g, tap e, tp n g
0 . . . 1 0 0
0 . . . 350 0
0 . . . 99 rp th
Determines the type of delay. The RP14D's Delay employs four types of Delay circuits: dig (Digital Delay with
clear concise repeats), dpng (Digital Ping Pong Delay with clear concise repeats which alternate between the
left and right outputs), tape (Tape Delay typical of the old tape delays with deterioration of each repeat), and
tpng (Tape Ping Pong with deteriorating repeats which bounce from side to side).
Controls the volume level of the delay. Ranges from 0 to 100.
Sets the time interval between repeats. The available delay time ranges are 0 (no delay) to 3.5 seconds.
Controls the number of repeats for the Delay. Ranges from 0 to 99, and rpth (repeat hold).
Section Three - Effects and Parameters
19