Communication Timeout; Snmp Communication Retries; Secure Protocol Settings; Login Settings - Kyocera KM-F1050 User Manual

Communication Timeout

SNMP Communication Retries

Secure Protocol Settings

Login Settings

Account Polling Settings

KMnet Viewer
these logical printer ports must match the port number entered in
Communication Settings.
A restart may be required for logical printer changes to take effect. Use the reset
page in the Command Center Basic tab.
Note: In older models, set the port number from the device home page. Select
Networking > Logical Printers. To restart, select General > Reset.
Enter the number of seconds the server should wait for the printing device to
respond to an SNMP or SOAP request. The available range is from 5 to 120
seconds.
Enter the number of times, after an initial failure, the application should attempt
to establish SNMP communication with the printing device. The available range
is from 0 to 5 retries. A higher number will increase network traffic, while a lower
number can improve performance.
Secure Sockets Layer (SSL) is a cryptographic protocol that provides security
for network communications. SSL support varies by network interface model.
Select SSL to use HTTPS for device communication.
Clear SSL to use HTTP for device communication.
The Login section lets you set user login information. The feature can be set if at
least one selected device supports the User Login feature.
For an account device, select whether to use Apply same user information
as Device Management (available when user information is stored in
Communication Settings) or Use another user's information. If Use
another user's information is selected, enter the Login user name and
Password for the device.
For some models, select whether to use local or device authentication.
Printing devices are interrogated at specific intervals to check for account
counter information. When a device is selected from an Accounting Devices
View, the following polling mode is provided.
Account counter polling
Information is gathered about the counters for each account, including total
number of prints, copies, fax, scans, page sizes, duplex pages, and pages
per sheet. Select an interval, a day or date, and time of day.
Communication Settings
5-2