Cisco Aironet AIR-AP1200 Hardware Installation Manual page 72

Mounting Above a Suspended Ceiling
The bracket mounting clip requires the use of an access point mounting bracket (700-13520-03) with
two extra holes (see
Figure 6-4
1 Extra holes
Follow these steps to mount the access point above a suspended ceiling.
Insert the bracket mounting clip's tab into the large hole on the access point mounting bracket.
Step 1
Place the clip over the T-bar box hanger and secure it to the access point mounting bracket (see
Step 2
Figure
Figure 6-5
Note
Determine the location in the ceiling where you will mount the access point and remove an adjacent
Step 3
ceiling tile.
Orient the access point 2-GHz antennas so that they are pointing down when mounted on the T-bar Box
Step 4
hanger. Orient the 5-GHz antenna for patch or omnidirectional operation as desired.
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
6-6
Figure 6-4).
Mounting Bracket Holes
1
6-5) with the 1/4-20 fastener (supplied with the T-bar hanger).
Access Point Mounting Bracket
The illustration shows the access point mounting bracket mounted perpendicular to the T-bar box
hanger. You can also mount the bracket parallel to the T-bar box hanger.
1
Chapter 6 Mounting Instructions
OL-4310-05