Mounting Instructions; Chapter 6 Mounting Instruction; Overview - Cisco Aironet AIR-AP1200 Hardware Installation Manual

Overview

Overview

You can mount the access point on any of the following surfaces:
•
•
The access point ships with a detachable mounting bracket and the necessary mounting hardware.
Because it is detachable, you can use the mounting bracket as a template to mark the positions of the
mounting holes for your installation. You then install the mounting bracket and attach the access point
when you are ready. Refer to
to use.
Figure 6-1
1
2
3
4
The Cisco Aironet 1200 Series Access Point provides adequate fire resistance and low smoke-producing
Note
characteristics suitable for operation in a building's environmental air space (such as above suspended
ceilings) in accordance with Section 300-22(C) of the National Electrical Code (NEC).
Caution Only the fiber-optic power injector (AIR-PWRINJ-FIB) has been tested to UL 2043 for operation in a
building's environmental air space; no other power injectors or power modules have been tested to UL 2043
and they should not be placed in a building's environmental air space, such as above suspended ceilings.
If you plan to mount the access point in environmental air space and will upgrade to a 5-GHz radio, Cisco
Note
recommends that you mount the access point horizontally with its antennas pointing down. Doing so will
result in the access point complying with regulatory requirements for environmental air space after the
5-GHz radio is installed.
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
6-2
Horizontal or vertical flat surfaces, such as walls or ceilings
Suspended ceilings
Figure 6-1
Mounting Bracket
1
2 8 3 7
Access point mount
Cable tie points
Ceiling mount holes
Access point mounts
to locate the various mounting holes for the method you intend
2 3
6 4 5
5
Locking detent
6
Wall cable access
7 Suspended ceiling cable access
8 Security hasp
Chapter 6

Mounting Instructions

4
OL-4310-05