Using The Web-Browser Interface For The First Time; Using The Management Pages In The Web-Browser Interface - Cisco Aironet AIR-AP1200 Hardware Installation Manual

Using the Web-Browser Interface for the First Time

Using the Web-Browser Interface for the First Time
Use the access point's IP address to browse to the management system. See the
Assigning an IP Address" section on page 3-3
point.
The access point web-browser interface is fully compatible with Microsoft Internet Explorer version 6.0
Note
on Windows 98 and 2000 platforms, and with Netscape version 7.0 on Windows 98, Windows 2000, and
Solaris platforms. .
Follow these steps to begin using the web-browser interface:
Step 1 Start the browser.
Step 2 Enter the access point's IP address in the browser address line and press Enter. The Summary Status
page appears.

Using the Management Pages in the Web-Browser Interface

The system management pages use consistent techniques to present and save configuration information.
A navigation bar is on the left side of the page, and configuration action buttons appear at the bottom.
You use the navigation bar to browse to other management pages, and you use the configuration action
buttons to save or cancel changes to the configuration.
Changes are applied only when you click Apply. It's important to remember that clicking your browser's
Note
Back button returns you to the previous page without saving any changes you have made. Clicking
Cancel cancels any changes you made on the page and keeps you on that page.
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
4-2
Chapter 4
for instructions on assigning an IP address to the access
Using the Web-Browser Interface
"Obtaining and
OL-4310-05