Table of Contents
Advertisement
Figure 4-4 HyperTerminal window
6)
Set HyperTerminal properties. Select File > Properties > Settings in the HyperTerminal to enter
the properties setting window, as shown in Figure 4-5. Select VT100 as the terminal emulation, and
click OK.
Figure 4-5 Set terminal emulation
Powering On the Access Controller
Checking Before Power-On
Before powering on the access controller, verify that:
The power cord and the ground wire are properly connected.
The power supply voltage is within the range that required by the access controller.
4-3
Advertisement
Table of Contents
