4
Initial Startup
Setting up the Configuration Environment
Connecting a Configuration Terminal to the Access Controller
For how to connect a configuration terminal to the access controller, refer to section "Connecting
Interface Cables" on page 3-14.
Setting Terminal Parameters
1)
Start the PC and run the terminal emulation program such as the Terminal of Windows 3.1 or the
HyperTerminal of Windows 95/98/NT/2000/XP.
2)
Select Start > Program > Accessories > Communications > HyperTerminal. On the
Connection Description interface, type the name of the new connection and click OK, as shown
in Figure 4-1.
Figure 4-1 Connection description interface
3)
The system displays the Connect To interface, as shown in Figure 4-2. From the Connect using
drop-down list, select the serial interface to be used. (Be sure to select the serial interface to which
the console cable is actually connected.)
4-1