3
Installation
When you ask your sales agent to maintain your access controller, you must ensure that the
dismantlement-preventive seal on a mounting screw of the access controller chassis is intact. If you
want to open the chassis, you should contact the agent for permission. Otherwise, you will bear any
consequence resulting from your actions.
Installation Procedure
Figure 3-1 Installation procedure
To a workbench
Check the workbench
Start
To a standard 19-inch rack
Where to install?
Using front and
rear mounting
brackets
Connect the
ground wire
Connect the
power cord
Connect device to
configuration terminal
Check the installation
Power on
No
Normal?
Yes
Install interface
modules
Connect device to
Ethernet
Connect device to LAN
Check the installation
End
3-1
Install the 19-inch rack
Select an
installation method
Using front
Using front
mounting brackets
mounting brackets
and a tray
and slide rails
Troubleshouting
Power off