Connecting Interface Cables; Connecting The Console Cable - 3Com WX5004 AC 4GE COMBO Installation Manual

5) Check the corresponding PWR LED on the front panel of the access controller. If the LED is solid
green, the AC power input is normal.
The AC power cord retainer can prevent the AC power cord from accidentally falling off.
Whether a power cord retainer is needed depends on the power supply system of the country.

Connecting Interface Cables

Connecting the Console Cable

1) Select a terminal for configuration.
The terminal can be a character terminal with a standard RS232 serial port or a PC. A PC is used in this
example.
2) Connect the console cable
Power off the access controller, connect the DB-9 female connector of the console cable to the serial
interface of the PC, and connect the RJ-45 connector of the console cable to the console port of the
access controller.
Pay attention to the interface mark and plug the connector to the right interface.
Figure 3-20 Connect the console cable
(1) RJ-45 connector
(4) Serial interface of the configuration terminal
(2)
(1)
(2) Console port
3-14
(5)
(3) DB-9 (female) connector
(5) Console cable
(3)
(4)