FUTABA FP-8SSHP Instruction Manual page 7

(19) Idle up 1 switch ( 1 switch)
Right ON, Left OFF.
(20) Idle up 1 ratcheted knob (1 knob)
•When the 1 switch [ 1 9] is set to ON, the throttle
servo "stop position" (idle up amount) can be
adjusted with this knob.
• If fail safe switch [13] on the trimmer panel at the
back of the transmitter is set to the INH posi-
tion, the idle up 1 function is inoperative. Light
goes out to indicate that. When switch [13] is set
to the IDLE1 position, monitor lamp [B] comes
on to indicate that the idle up 1 function is
operative. If the switch [19] is then set to ON,
lamp [B] flashes to indicate that the idle up I
function is operating.
Throttle servo
Idle up I point Adjustable with
trimmer 9 on the trimmer
panel at the back of the
transmitter.
(21) Idle up 2 switch ( 2 switch)
Right ON, Left OFF.
•When the 2 switch [21] is set to ON, the throttle
servo idle up point can be adjusted with trimmer
[10] on the trimmer panel at the back of the trans-
mitter. The idle up 2 point can also be adjusted
with trimmer [11].
•When fail safe switch [14] on the trimmer panel at
the back of the transmitter is set to the INH posi-
tion, the idle up 2 function is inoperative. When
the switch is set to the IDLE2 position, monitor
lamp [C] comes on to indicate that the idle up
2 function is operative. If the 2 switch [21] is
then set to ON, lamp [C] goes out to indicate that
the idle up 2 function is operating.
•The pitch control servo low side can also be
adjusted with trimmer [6] (when idle up switch
2 is ON). This is convenient in rolls and other
aerobatics.
Fig. 10
Pitch control servo
Throttle servo
Idle up 2 point Adjustable
with trimmer [11] on the
trimmer panel at the back of
transmitter.
Fig. 11
When the idle up 2 switch
is ON, the pitch control
servo can be varied 50% at
the pitch low side with
trimmer 6 on the trimmer
panel in the back of the
transmitter.
Pig. 12
5