FUTABA FP-8SSHP Instruction Manual page 30

• The inverted flight function can be turned on and off with the [C] inverted flight FS switch on the trimmer panel
at the back of the set.
* INVERT: Inverted flight function ON
INH : Inverted flight function OFF
•When the [C] switch is in the INVERT (function ON) position, normal flight <-> inverted flight switching can be
performed with the [26] Inverted flight ON-OFF switch at the side top corner of the transmitter.
* When the [26] switch is pushed, normal flight is selected. At this time, the pitch can be adjusted with trim-
mers [3, 4
time, the pitch control servo, elevator servo, and rudder servo are reversed and the pitch control servo low-
side and high-side throws can be adjusted with trimmer [A] and [B].
When the [C] inverted flight FS switch and [26] Inverted flight ON-OFF switch are switched, the
[A] inverted flight low-side trimmer and [B] inverted flight high-side trimmer operate the pitch
control servo (servo connected to channel 6 of the receiver) as shown in the figure.
Throttle lever
neutral
28
When switch [C] is set to
the INH position, the pitch
control servo operates nor-
mally.
5, 6, and 7] as usual. When the
When the [C] switch is in
the INVERT position and
the [26] switch is pushed
( I N V E R T OFF)
[NORMAL FLIGHT]
[26] switch is pulled, inverted flight is selected. At this
Can be adjusted
over this range with trim-
mer [B]
When the [C] switch is in
the INVERT position and
the
(INVERT ON)
[INVERTED FLIGHT]
Fig. 64
and set
Can be adjusted and set
over this range with trim-
mer [A]
[26] switch is pulled