PCM RECEIVER FP-R118GP
Antenna wire
Crystal
Error lamp
• System checking can be performed with this lamp.
•When the receiver and servo side Nicd is connect-
ed and this LED is on, radiowaves are not being
received from the transmitter, check to be sure
the frequency is correct. Checking is possible by
the lamp being on.
22
•When
strong noise has been received, or the
radiowaves from the transmitter are intermit-
tently interrupted, this lamp will blink.
This usually is not a problem.
Receiver crystal
Fig. 56
Remove the receiver crystal by
pulling it in this direction.
Fig. 58
Receiver, servo switch, and battery
connections
Antenna
wire
PCM receiver
FP R118GP
Power switch
SWH-5 (R4-SWJ)
Charging connector
NR-4J
Pay careful attention to the
connector polarity.
AEC-3
Extension cord
Fig. 59