FUTABA 9VAP Instruction Manual page 30

ADJUSTMENTS AND FLIGHT TECHNIQUES
F3A Pattern Aircraft
The figures below show multiple mixing func-
tions in an F3A contest aircraft. Both built-in
and Programmable mixing functions are used.
Elevator Flap (CH6) mixing and Aileron Dif-
ferential (CH1 and CH7) are used. In addition,
the PROG-MIX function is used to allow the
ailerons (CH1 and CH7) to act as flaps (flap-
perons) when ELV -> FLP mixing is ON.
Setting Method
1) Elevator flap Mixing (Built-in)
Press the program key.
Flap Mixinq, paqe
See Elevator
2) Aileron Differential Mixing (Built-in)
Press the program key.
See Aileron Differential Mixing, page
3) Set PROG MIX
1. Select the Programmable Mixing CHAN-
NEL SETTING screen.
2. Set the "mas" channel to FLP with the
or program key.
3. Press the program key. ("Slaves" the
PROG MIX 1 circuit to the built-in ELV ->
FLP circuit.)
4. Move the cursor to the "slv" position with
the cursor key and set the "slv" chan-
nel to AIL with the
5. Press the program key. ("Slaves" the
built-in AIL DIFF circuit to the PROG
MIX 1 circuit.)
All the mixing channels are now designated. The
screen should appear as below.
6. Return to the PROGRAMABLE MIXING
screen by pressing the
7. Move the cursor to the "inn" position and
press the key.
8. Move the cursor to the "sw" position and
select the ON/OFF switch option desired.
4) Rate
5) Aileron differential is set with the AILERON
6) UP and DOWN movement of the Ailerons
key. or
program key.
(amount) of movement of the FLP
(CH6) servo in relation to the Elevator control
stick is set in the ELV -> FLP mixing screen
(page 40).
DIFFERENTIAL screen (page 32).
(CH1 and CH7) in relation to Elevator stick
movement will be influenced by the rate set
for ELV -> FLP mixing and by the rate set at
U/R and L/D on the PROGRAMABLE MIX-
ING screen. If the U/R and L/D rates are set
at 100%, then the UP and DOWN movement
of the Ailerons (at ELV -> FLP MIX ON) will
be the same as set in Step 4) above.