FUTABA 9VAP Instruction Manual page 28

ADJUSTMENTS AND FLIGHT TECHNIQUES
•Combinations allow more efficient use of the
number of mixing circuits. An example is
shown below.
When and are not used, three circuits
are required for the mixing program shown
below. Programable mixing is performed from
Aileron to Elevator and Rudder, and from Eleva-
tor to Rudder. This is the same as AIL -> ELV ->
RUD mixing.
The same mixing program as in Example 1 can be
set up usinq only two 2 mixinq circuits when the
and functions are used.
MX1 is set to AIL -> ELV mixing.
MX2 is set to ELV -> RUD mixing.
The cursor is moved to the MX1 "slv" position,
• Activation of Programmable Mixing Circuits
1) Move the cursor to the ' INH" position with
the or cursor key.
2) To activate the circuit, press the
"ON" or "OFF" will be displayed according
to the position of the designated Mixing ON/
OFF switch.
3) To deactivate the mixing circuit, press the
program key.
and is set. The cursor is then moved to the
"mas" position and
OFF (Set to
This is also the equivalent of AIL -> ELV -> RUD
mixing.
Setting MX1 as the MX2 Master channel in the
example is the same as setting XON .
• Combinations are effective when the number
of mixing circuits is insufficient, and when
PROG-MIX circuits are mixed with built-in
mixing circuits.
• Mixing Rate and Direction Setting
The mixing rate setting determines the amount
of deflection of the Slave servo in relation to
movement of the Master channel control stick or
key.
lever. Both the amount (rate) and direction (+ or
-) of movement can be set independently, either
side of the mixing point (neutral).
1) Move the cursor to the R/U or L/D position
with the
2) Set the desired rate with the
program key.
3) The servo operating direction can be changed
with the
[26]
is set. MX3 is turned
).
or cursor key.
and program keys.
, or