Flp-Ele - FUTABA 7CAP Instruction Manual

FLAP-ELEV mixing (ACRO ):
Adjustability:
Rate: -100% (full up elevator) to +100 (full down elevator), with a default of +50% (one-half of the elevator range is
achieved when the flaps are lowered to full range.)
Offset: offsets the elevator's center relative to the flaps.
GOAL of EXAMPLE:
Activate FLAP-ELEV mixing. Adjust
elevator travel to 45%.
Where next?
FLAP-ELEV mixing is a pre-programmed linear mix. This mix makes the elevator
move whenever the flaps are moved. This mix is used to compensate for any
pitching created by the flap.
STEPS:
Open the FLAP-ELEV function.
Activate the function.
Adjust the travels as needed.
(Ex: +45%)
Close menu.
View additional setups on the internet:
50
INPUTS:
for 1 second. (If basic,
to FLAP-ELEV.
to ON.
to 45%.
www.futaba-rc.com\faq\faq-7c.html.
again.)