FUTABA 7CAP Instruction Manual page 13

NOTE: If you need to remove or replace the transmitter battery, do not pull on its wires to remove it. Instead,
gently pull on the connector's plastic housing where it plugs into the transmitter.
SWITCH ASSIGNMENT TABLE
•
The factory default functions activated by the switches and knobs for a Mode 2 transmitter are shown below.
•
Most 7C functions may be reassigned to non-default positions quickly and easily.
•
Basic control assignments of channels 5 & 7 are quickly adjustable in PARA (see p. 28). For example, the channel 5
servo, which defaults to S
rudder servo in a mix, or to a dial for bomb door or other control.
•
Note that most functions need to be activated in the programming to operate.
•
Mode 1 transmitter functions are similar but reverse certain switch commands. Always check that you have the desired
switch assignment for each function during set up.
Switch/Knob
A or H Tx.
S A
WITCH
Switch B
S D
WITCH
Switch E G*
OR
Switch F H*
OR
S G E*
WITCH OR
K VR
NOB
* On the 7CA (mode 2) transmitters, the Top Left Switches are spring-loaded switch and 2-position switch. On the 7CA (mode 1) and 7CH
transmitters, the Top Left Switch is a 3-position with the spring loaded switch on the top right.
Ni-Cd battery pack
Charging jack
Battery connector location
E for retract use, can easily be unassigned (NULL ) to allow for easy use as a second
WITCH
Airplane (ACRO)
elevator dual rate
rudder dual rate
aileron dual rate
landing gear/ch 5
snap roll/trainer
up = ELE-FLPon
down = AIRBRAKE on
flap/ch 6
(flap trim if FLAPERONon)
Trainer connector
Battery cover
Helicopter (HELI)
elevator dual rate
rudder dual rate
aileron dual rate
throttle hold
trainer
idle-up 1 and 2,
ch5/OFFSET/GYRO
HOVERING PIT
13