Troubleshooting - FUTABA 2PL Instruction Manual

If your digital proportional R/C set does not operate, its range is short, it intermit-
tently stops operating, or it operates erroneously, take the action shown in the table
below. If this does not correct the trouble, please contact a Futaba dealer.
Check point
Transmitter/receiver
battery
Transmitter antenna
Crystal
Connector connection
Receiver antenna
Servo linkage
Motor
Makuhari Techno Garden Bldg., B6F 1-3 Nakase, Mihama-ku, Chiba 261-8555, Japan

Troubleshooting

Check item
Dead battery.
Incorrect loading.
Faulty contact con-
nection.
Dirty contacts.
Loose.
Not extended to full
length.
Disconnected.
Wrong band.
Different from specifi-
cation.
Incorrect wiring.
Disconnection.
Close to other wiring.
Not cut?
Not bundled?
Binding or looseness
Noise countermea-
sures.
FUTABA CORPORATION
Phone: (043) 296-5119 Facsimile: (043) 296-5124
Action
Replace the battery. / Charge the Nicd
battery.
Reload the batteries in the correct
polarity.
If the contact spring is deformed,
correct it.
Wipe with a dry cloth.
Screw in.
Extend fully.
Push in.
Match transmitter/receiver band.
Replace with specified crystal.
Reinsert.
Push in.
Separate from other wiring.
Request repair.
Install in accordance with instruction
manual.
Adjust at the model side.
Install a noise absorbing capacitor.
©FUTABA CORPORATION 2003, 06
19