How To Sew On A Button - ELNA 6001 Instruction Book

PDFMAILER.DE
02

How To Sew On a Button

Hand sewing buttons to a garment is very time-con-
suming. Sew them on in one quick, easy step.
Drop the feed dog. See page 7.
Set the stitch width according to the position of
the holes in the button.
Mark button placement on fabric. Use washable glue
or transparent tape to temporarily secure the button.
Place the button and fabric under the presser foot.
Match the holes in the button to the horizontal slot
on the presser foot.
Turn the flywheel by hand until the needle is down
inside the left hole of the button. Lower the presser
foot.
.
Turn the flywheel by hand to position the needle
above the right hole of the button. Press the
to adjust the needle over the right hole.
Stitch several times.
After you finish sewing, cut the thread leaving 10-15
cm (4-6") of thread at the button.
Pull the thread to the reverse side of the fabric and
tie the threads.
Raise the feed dog after sewing on buttons.
NOTE: The optional Sewing on Button foot grips the
button better and also allows you to create a thread
shank. Simply insert a pin into hole on front of foot
before sewing. After sewing, wrap thread tails to cre-
ate shank.
32
key