Additional Spool Pin - ELNA 6001 Instruction Book

PDFMAILER.DE
5
6
7
n Place the bobbin on the bobbin winder spindle
o Holding the free end of the thread, press the foot
p Move the spindle to the left to return the bobbin
5

Additional Spool Pin

The additional spool pin can be used to wind an ex-
tra bobbin without unthreading the machine.
4
PROCEDURE: Insert the spool stand k and the ad-
ditional spool pin l in the hole j. Place the felt m
and spool n on the pin with the thread coming off
3
the spool as shown.
2
1
17
and push it to the right. The LED readout will
display "SP."
control. Stop the machine when it has made a
few turns and cut the thread tail close to the
hole in the bobbin. Press the foot control again.
When the bobbin is fully wound, it will stop auto
matically.
winder to its original position. Cut the thread as
shown.