Connect Dtu-710 To A Computer - Wacom DTU-710 - MANUAL 2 User Manual

Connect DTU-710 to a computer

Connect DTU-710 to a computer as adisplay.
Do not use any cable that did not come with DTU-710; use of an improper cable
may damage DTU-710.
Make sure your graphics card has a VGA or DVI connector, and that you correctly
set the DTU-710 Analog (VGA)/Digital (DVI) switch for the graphics card you are
using. The use of an improper video card may damage DTU-710.
Do not connect or disconnect the video or power cable while DTU-710 or your
computer are turned on; this can damage the LCD display or computer video card.
Never connect or disconnect the DVI video cable or power cable while your computer
or DTU-710 is powered on. This can damage the LCD display or video card.
1.
Turn off your computer. The cover in the rear of DTU-710 is made to slide in the
direction of " ▶ ", and is removed.
2.
Connect the DVI-to-DVI cable or DVI-to-VGA cable between DTU-710 and your
computer.
3.
Set the DVI/VGA switch. Move it up for analog (VGA) mode, and move it down for
digital (DVI) mode.
4.
Connect the AC adaptor to DTU-710.
5.
Connect the AC adaptor power cable and plug the adaptor into an AC outlet.
Be sure to connect an earth cable.
6.
Turn on the power switch of DTU-710. The power lamp will light blue, and then
turns orange.
7.
Turn on your computer to start your operating system.
8.
The maximum resolution of DTU-710 is 1280 x 1024, True Color . As necessary,
configure the monitor control panel settings for the proper size and color resolution.
The number of colors is constrained by the performance of your computer or
graphics card. Refer to the documentation of the manufacturer for details.
If you are using analog (VGA) mode, you may also want to fine-tune the display.
Please refer to Adjusting the LCD Monitor on page 22 for more information.
9.
To install the Wacom tablet software, turn off your computer and connect the USB
cable or serial data cable.
10.
Fix cables to a cable guides. Shut the connector cover is and take out the cables
from the hole of the cover.
11.
Install tablet software. Refer to Tablet Software Installation for Windows and
Macintosh on page 8 .
6
CAUTION