Adjusting The Lcd Monitor; Factory Presets, Multi-Sync, And User Settings; Working With Osd (On Screen Display) Menu - Wacom DTU-710 - MANUAL 2 User Manual

Adjusting the LCD Monitor

Factory Presets, Multi-sync, and User Settings

Factory Presets: To display images with the best quality (based on the incoming
signal), DTU-710 comes with a number of factory default standard display modes.
Multi-Sync: When connected as a VGA display, DTU-710 attempts to automatically
synchronize to the incoming signal. Multi-Sync functions if the horizontal frequency is
between 30 to 80 kHz and the vertical frequency is between 50 to 75 Hz. If DTU-710
does not automatically synchronize with the incoming signal, you can use the OSD
Reset Auto Adjust option to initiate display synchronization. If necessary, further
screen display adjustments can be manually made using the On Screen Display (OSD)
controls.
User Settings: When you manually set the display using the On Screen Display (OSD)
function, the settings are stored within DTU-710 for use the next time the unit receives
a similar signal. This is applicable to all display modes.

Working with OSD (On Screen Display) Menu

To open the main MENU, press the MENU ( ) button.
Use the + ( ) or - ( ) buttons to select an option. When the option you want to adjust
is highlighted, press the ENTER ( ) button. The current settings and adjustment sub-
menu for that option will appear.
Use the + ( ) or - ( ) buttons to adjust the option settings.
When you have made your changes, press the ENTER ( ) button to save. To
exit, press the MENU ( ) button. All settings are automatically saved when the OSD
menu closes.
Contrast
Select to increase or
decrease image contrast.
Brightness
Select to increase
or decrease image
brightness.
22
Phase (VGA only)
Select to reduce or
eliminate horizontal
distortion lines.
☞ P24
To automatically
adjust, use the RESET
option.
Pitch
(VGA only)
Select to reduce or
eliminate vertical
distortion lines.
☞ P24
To automatically
adjust, use the Reset
option.