Using Multiple Interactive Pen Displays - Wacom DTI-520 User Manual

Using Multiple Interactive Pen Displays
When multiple interactive pen displays are connected and are to be used, it is necessary to set up the
pen and calibrate for each interactive pen display individually. Please follow the procedures below to
carry this out.
1
Bring the pen tip near the display for which the setup is to take place. Verify that the pointer
moves in conjunction with the pen tip.
2
Open the control panel. (Please refer to the screenshot accompanying Step 1 of the procedure
described in "Blurring and Protrusion of the Picture from the LCD Panel" on P. 14)
3
Open the Calibrate tab and verify that the correct monitor name is displayed in the Monitor field.
● If Another Monitor Name is Displayed in the Monitor Field...
The control panel of a different interactive pen display is being displayed. Press the ESC key on
the keyboard to close the control panel and, beginning with Step 1, repeat the above procedure
to display the correct control panel.
*If the monitor name is changed without displaying the control panel, the tablet will not be set up correctly.
【Important】
When more than one interactive pen tablet is connected, the control panel of the last
tablet to recognize the pen tip is displayed. Even after identifying the pointer, if you
use the pen on another tablet to open its control panel, the pen tip is recognized and
the control panel of this tablet opens. Please refer to the following example.
Example ＞ Setting up Display A when Displays A and B are connected.
1. The pointer is identified by Display A.
2. The control panel of Display A is displayed. → OK
The pen is used on Display B to display the control panel → NOT OK (This carries out the
setup of Display B)
The computer mouse is used on Display B to display the control panel → OK
4
Refer to "Blurring and Protrusion of the Picture from the LCD Panel" on P. 14 and carry out calibra-
tions.
To set up the pen, open the PEN tab, refer to "Switch and Button Settings" on P. 21 and carry out the
setup.
5
Repeat Steps 1 – 4 to set up another display.
Caution

UM-0314(A)_EN.indd 24
Depending on your PC graphics card or driver, multi-monitor set up may not be
available.
2007/11/12 16:53:19