Replacing The Back Cover - Cisco AIR-AP1121G-E-K9 Hardware Installation Manual

Replacing the Back Cover

Replacing the Back Cover

To replace the back cover on the access point, follow these steps:
Step 1 While holding the back cover near the connector end of the access point, position it at a slight angle and
carefully place the latches on the antenna end into the detents on the antenna end of the front cover (refer
to Figure
Figure 7-6
1
2
Release the back cover and with one finger gently push the connector end of the back cover towards the
Step 2
antenna end. The back cover drops into place and slides forward until it is fully seated.
Use a Philips screwdriver to hand tighten the cover's retaining screw.
Step 3
Remove the backing paper from the 1100 series access point product compliance label and carefully
Step 4
place the new label over the existing label (see
Figure 7-7
1
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
7-8
7-6).
Positioning the Back Cover Latches
1
4
Back cover
Antenna end latch
Location of Compliance Labels
Product compliance label
3
Antenna end detent
4
Front cover
Figure 7-7).
2
1
2
Chapter 7 2.4-GHz Radio Upgrade
2
3
Back cover
OL-4309-02