Overview - Cisco AIR-AP1121G-E-K9 Hardware Installation Manual

Overview

Overview
The mounting brackets and hardware shipped with your access point enables you to mount it on any of
the following surfaces:
•
•
•
•
The 1100 series access point provides adequate fire resistance and low smoke-producing characteristics
suitable for operation in a building's environmental air space, such as above suspended ceilings, in
accordance with Section 300-22(C) of the National Electrical Code (NEC) and Sections 2-128,
12-010(3) and 12-100 of the Canadian Electrical Code, Part 1, C22.1.
Caution Cisco Aironet 1100 Series Power Injectors and the universal power supplies are not tested to UL 2043
and should not be placed in a building's air-handling spaces, such as above suspended ceilings.
Security features for each of these mounting methods are also provided. You can use a Kensington lock
(Notebook Microstar, model number 64068), which you must provide, to make the access point more
secure when you mount it using any of the mounting options.
You can use the security hasp adapter provided by Cisco to secure the access point with a padlock when
you use the wall or ceiling mounting bracket. The security hasp adapter provides maximum physical
security for your access point.
A mounting hardware kit is provided that contains the hardware and fasteners necessary to mount the
access point. Refer to
to the section containing the specific mounting procedure.
Table 6-1
Mounting Method
Horizontal or vertical surface
Suspended ceiling
Office cubical wall partition
Desktop
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
6-2
Horizontal or vertical flat surfaces, such as walls or ceilings
Suspended ceilings
Cubical partition walls
Desktop or other suitable horizontal surface
Table 6-1
Mounting Material
to identify the materials you need to mount your access point, then go
Materials Required
Wall or ceiling mounting bracket
Security hasp adapter
Four #8 x 1 in. (25.4 mm) screws
Four wall anchors
3/16 in. (4.7 mm) or 3/32 in. (2.3 mm) drill bit
Drill
Wall or ceiling mounting bracket
Security hasp adapter
Two caddy fasteners with studs
Two plastic spacers
Two 1/4–20 Keps nuts
Standard screwdriver
Appropriate wrench or pliers
Cubical partition mounting bracket assembly
Desktop holster
Chapter 6 Mounting Instructions
In Kit
Yes
Yes
Yes
Yes
No
No
Yes
Yes
Yes
Yes
Yes
No
No
Yes
Yes
OL-4309-02