Figure 4-15: New Hardware Found; Figure 4-16: Search For Driver; Figure 4-17: Driver Installation Complete - Linksys WCG200 - Wireless-G Cable Gateway Wireless Router User Manual

Wireless-G Cable Gateway
Installing the USB Driver for Windows Millennium
1. Start up your PC in Windows Millennium. Windows will detect new hardware connected to your PC. Insert the
Setup CD into your CD-ROM drive.
2. Select Automatic search for a better driver (Recommended) and click the Next button.
3. Windows will begin installing the driver for the modem. At this point, the installation may require files from
your Windows Millennium CD-ROM. If prompted, insert your Windows Millennium CD-ROM into your CD-ROM
drive and enter d:\win9x in the box that appears (if "d" is the letter of your CD-ROM drive). If you were not
supplied with a Windows CD-ROM, your Windows files may have been placed on your hard drive by your
computer manufacturer. While the location of these files may vary, many manufacturers use
c:\windows\options\install as the path. Try entering this path into the box. If no files are found, check your
computer's documentation or contact your computer manufacturer for more information.
4. When Windows finishes installing the driver, click Finish.
5. When asked if you want to restart your PC, remove all CD-ROMs from the PC and click Yes. If Windows does
not ask you to restart your PC, click the Start button, choose Shut Down, choose Restart, and then click Yes.
6. The Windows Millennium driver installation is complete.
IMPORTANT: Make sure to contact your Cable ISP with the Gateway's MAC address after the
Gateway is powered on, so they can activate your account or you will not have Internet access.
7. Contact your Cable ISP to activate your account. Your Cable ISP will need what is called a MAC Address for
the cable modem capability of the Gateway in order to set up your account. The 12-digit modem MAC address
is printed on a bar code label on the bottom of the Gateway. Once you have given them this number, your
Cable ISP should be able to activate your account.
The Online LED flashes when the Gateway is establishing a connection to your cable ISP. When the Cable is
synchronized with your cable ISP, the LED will be solidly lit.
The Gateway's hardware installation is now complete. Go to "Chapter 5: Configuring the Gateway."
Chapter 4: Connecting the Wireless-G Cable Gateway
Wired USB Connection to a Computer

Figure 4-15: New Hardware Found

Figure 4-16: Search for Driver

Figure 4-17: Driver Installation Complete

14