The Front Panel; Figure 3-2: Front Panel - Linksys WCG200 - Wireless-G Cable Gateway Wireless Router User Manual

Wireless-G Cable Gateway

The Front Panel

The Gateway's LEDs, which displays information about network activity, are located on the front panel.
Power Green or red. The green Power LED is solidly lit when the Gateway is powered on. If the
LED lights up red, there is an error.
Internet, DS Green. The DS (Downstream) LED lights up and flashes when the Gateway is trying to lock
on a downstream signal. The LED stays solidly lit when it has locked on the signal.
Internet, US Green. The US (Upstream) LED lights up and flashes when the Gateway is trying to lock on
an upstream signal. The LED stays solidly lit when it has locked on the signal.
Internet, Online Green. The Online LED flashes when the Gateway is establishing a connection to your cable
ISP. It is solidly lit when the Gateway is synchronized with your cable ISP.
Ethernet-1-4 Green or red. Ethernet 1-4 LED serves multiple purposes. If the LED is solid green, the
Gateway is successfully connected to a device through the corresponding port (1, 2, 3, or
4). If the LED is flashing green, the Gateway is actively sending or receiving data over that
port. If the LED lights up red, there is a collision.
USB Green or red. The LED is solid green when a PC is connected to the Gateway via USB, and
drivers are installed. If the LED flashes red, the cable is connected, but the driver isn't
loaded.
Wireless Green or red. The LED flashes green during wireless activity. If the LED flashes red, there is
an error.
Chapter 3: Getting to Know the Wireless-G Cable Gateway
The Front Panel

Figure 3-2: Front Panel

NOTE: If the US and DS LEDs are flashing, the
Gateway is still operating, but your Internet
service has been disabled by your Internet
Service Provider (ISP).
NOTE: If the US, DS, and Online LEDs are flashing,
the Gateway is performing a self-test.
7