Linksys WAP54GPE - Wireless-G Exterior Access Point User Manual page 23

Wireless-G Exterior Access Point
• Advanced Wireless Settings. Use this screen to configure the Access Point's more advanced wireless
settings (e.g. Wireless Isolation, Output Power, etc.).
AP Mode
Use this screen to configure the Access Point operation mode with WDS (Wireless Distribution System).
Administration
You will use the Administration tabs to manage the Access Point.
• Management. This screen allows you to customize the password and Simple Network Management
Protocol (SNMP) settings.
• Log. Configure the Log settings for the Access Point on this screen.
• Factory Default. Use this screen to reset the Access Point to its factory default settings.
• Firmware Upgrade. Upgrade the Access Point's firmware on this screen.
• Reboot. Use this screen to reboot the Access Point.
• Config Management. You can back up the configuration file for the Access Point, as well as save the
backup configuration file to the Access Point.
Status
You will be able to view status information for your local network, wireless networks, and network
performance.
• Local Network. This screen displays system information, including software & hardware version, MAC
address, and IP address on the LAN side of the Access Point.
• Wireless. This screen will display current information on the Access Point and its wireless networks.
• System Performance. This screen will display current information on the Access Point and its data
transmissions.
Chapter 5: Setting Up the Wireless-G Exterior Access Point
Navigating the Utility
snmp: the standard network management
protocol on the Internet.
firmware: the software image that runs on a
CPU inside a networking device.
16