Group 2 Operation Method Parameters - Delta Electronics Network Device VFD-S User Manual

Pr.
1-04 Mid-Point Voltage (Vmid)
1-05 Minimum Output Frequency (Fmin)
1-06 Minimum Output Voltage (Vmin)
1-07 Output Frequency Upper Limit
1-08 Output Frequency Lower Limit
1-09 Accel Time 1
1-10 Decel Time 1
1-11 Accel Time 2
1-12 Decel Time 2
1-13 Jog Acceleration / Deceleration Time
1-14 Jog Frequency
Auto acceleration / deceleration (refer
1-15
to Accel/Decel time setting)
1-16 Acceleration S-Curve
1-17 Deceleration S-Curve
1-18 Jog Decelerating Time

Group 2 Operation Method Parameters

Pr.
Source of Master Frequency
2-00
Command
Revision August 2008, SE09, SW V2.61
Explanation
Explanation
Chapter 5 Parameters|VFD-S Series
Settings
230V series: d2.0V to d255V
460V series: d4.0V to d510V
d1.0 to d60.0 Hz
230V series: d2.0V to d255V
460V series: d4.0V to d510V
d1 to d110%
d0 to d100%
d0.1 to d600 Sec
d0.1 to d600 Sec
d0.1 to d600 Sec
d0.1 to d600 Sec
d0.1 to d600 Sec
d1.0 Hz to d400 Hz
d0: Linear Accel/Decel
d1: Auto Accel, Linear Decel
d2: Linear Accel, Auto Decel
d3: Auto Accel/Decel (Set by load)
d4: Linear Accel; Auto Decel, Stall
Prevention during Decel
d5: Auto Accel/Decel, Stall
Prevention during Decel
d0 to d7
d0 to d7
d0.0 Jog Decelerating Time
Determined by Pr.1-13
d0.1 to d600
Settings
d0: Master Frequency input
determined by digital keypad.
(record the frequency of power
loss and it can do analog
overlap plus)
d1: Master Frequency determined
by analog signal DC 0V-10V
(external terminal AVI). (won't
record the frequency of power
loss and it can't do analog
overlap plus)
d2: Master Frequency determined
by analog signal DC 4mA -
20mA (external terminal AVI).
(won't record the frequency of
power loss and it can't do
analog overlap plus)
Factory
NOTE
Setting
d12
d24
d1.0
d12.0
d24.0
d100
d0
d10.0
d10.0
d10.0
d10.0
d10.0
d6.0
d0
d0
d0
d0.0
Factory
NOTE
Setting
d0
5-3