Storage - Delta Electronics Network Device VFD-S User Manual

Chapter 1 Introduction|VFD-S Series

1.4 Storage

The AC motor drive should be kept in the shipping carton or crate before installation. In order to
retain the warranty coverage, the AC motor drive should be stored properly when it is not to be used
for an extended period of time. Storage conditions are:
Store in a clean and dry location free from direct sunlight or corrosive fumes.
Store within an ambient temperature range of -20
Store within a relative humidity range of 0% to 90% and non-condensing environment.
Store within an air pressure range of 86kPa to 106kPa.
CAUTION!
1. DO NOT store in an area with rapid changes in temperature. It may cause condensation and
frost.
2. DO NOT place on the ground directly. It should be stored properly. Moreover, if the surrounding
environment is humid, you should put exsiccator in the package.
1-4
SCREW
DIVISION
PLATE
CONDUIT
BRACKET
SCREW
SCREW
Reinstall Division Plate.
Screw Torque: 5 to 6 kgf-cm (4.3 to 5.2 in-lbf)
Install Conduit Bracket cover and tighten screws.
° °
C to +60 C.
Revision August 2008, SE09, SW V2.61