Toshiba DF03A - IK CCTV Camera Instruction Manual page 26

6.10 OTHERS MENU
6.10.1 POWER UP
During Power-Up, the dome camera can be set to start in various modes.
PARK:
AUTO SCAN:
FRAME SCAN:
RANDOM SCAN:
AUTO PATROL:
DEFAULT:
Menu
To set POWER UP MODE:
1. Enter the preset command to access the main menu.
Refer to section 6.1 for the controller model and preset command.
2. Position the cursor ( ) next to OTHERS and press the OPEN button to access the menu.
3. Position the cursor next to POWER UP and press the OPEN button to move the cursor to the
right.
4. Move the joystick up or down to set the power up mode.
5. To accept the selection, press the OPEN button or to cancel the selection, press the CLOSE
button.
Downloaded from www.Manualslib.com
The dome camera moves to Preset 1 position.
The dome camera performs an auto scan operation.
The dome camera performs a frame scan operation.
The dome camera performs a random scan operation.
The dome camera performs an auto patrol operation.
The dome camera moves to the mechanical reset point.
MAIN MENU
<CAMERA SETUP>
<PAN/TILT SETUP>
<PRESET TITLES>
<OTHERS>
EXIT
manuals search engine
OTHERS MENU
POWER UP
FREEZE ACTIVITY ON
LOAD FACTORY DEFAULT
TILT ANGLE OUTDOOR
- 26 -
PARK