Using An Alternate Mount Or Stand - Wacom CINTIQ 17SX Installation Manual And User's Manual

USING AN ALTERNATE MOUNT OR STAND

If you will be using the DTU-710 in an
installation that requires the use of an
alternate mounting platform, you can
remove the adjustable stand from the unit
and mount the pen display onto a VESA
conforming mount arm or stand.
A VESA mounting platform will require
mount screws that are 4 mm wide with a
0.7 mm pitch (M4 Regular), and a
maximum screw clearance depth of 15 mm.
Exceeding the clearance depth of 15 mm
will damage the DTU-710 internal
components.
To remove the adjustable stand and attach
the DTU-710 to a different mounting
platform:
1. Turn off your computer and power off
the DTU-710. Then disconnect all
cables from the unit.
2. Protect the display screen surface by
spreading a soft cloth onto a flat table
and placing the DTU-710 face down on
the cloth.
3. Remove the four screws and lift the
adjustable stand assembly away from
the body of the unit.
4. Using the appropriate screws for your
mounting platform, firmly attach the
DTU-710 to the alternate mounting
platform.
5. Refer to the Installation instructions,
beginning on page 9, and reattach the
cabling.
C
AUTION
When attaching the DTU-710 onto an
alternate mounting platform, be sure to
follow all instructions in the
documentation supplied by the platform
manufacturer. If improperly installed,
the unit could fall, resulting in damage
to the unit or physical injury.
APPENDICES
Page 40