Using An Alternate Mount Or Stand - Wacom DTF-720 Installation Manual And User's Manual

Using an alternate mount or stand

If you will be using the DTF-720 in an
installation that requires the use of an
alternate mounting platform, you can
remove the adjustable stand from the unit
and mount the pen display onto any mount
arm or stand conforming to the VESA 75
standard.
Mounting screws that are 4 mm wide with a
0.7 mm pitch (M4 Regular), with a screw
clearance depth of 15 mm are required.
Exceeding the clearance depth of 15 mm
will damage the DTF-720 internal
components.
To remove the adjustable stand and attach
the DTF-720 to a different mounting
platform:
1. Turn off your computer and power off
the DTF-720. Then disconnect all
cables from between the unit and your
computer.
2. Protect the display screen surface by
spreading a soft cloth onto a flat table
and placing the DTF-720 face down on
the cloth.
3. Remove the four screws and lift the
adjustable stand assembly away from
the body of the unit.
4. Using the appropriate screws for your
mounting platform, firmly attach the
DTF-720 to the alternate mounting
platform.
5. Refer to the Installation instructions,
beginning on page 9, and reattach the
cabling.
C
AUTION
When attaching the DTF-720 onto an alternate mounting platform,
be sure to follow all instructions in the documentation supplied by
the platform manufacturer. If improperly installed, the unit could fall,
resulting in damage to the unit or physical injury.
Appendix
Page 41