Accessing The Configuration Options; Options Available For Nview Clone And Span Modes; Clone Mode - Nvidia P128 - Quadro FX2000 Dual Graphic Card 8x 128MB Model OEM User Manual

C h a p t e r 7

Accessing the Configuration Options

On the nView Display Mode panel, the monitor image numbered 1 represents
the primary display device.
In Standard (Dualview) mode, only one monitor image appears.
In Clone and Span modes, the monitor image numbered 1 represents the
primary display device and the monitor image numbered 2 represents the
secondary display device.
To access nView configuration options, use any one of these procedures:
• Right click the monitor image (1 or 2) to display a pop-up menu, and than
click the option you want.
• Click the down arrow in the Display field to select the display device (i.e.,
nView Display 1 or nView Display 2) you want to configure. Then click
Device Settings to display a menu of options and choose the option you
want.

Options Available for nView Clone and Span Modes

Make this the primary display: Use this option to select the display that
contains the top left corner of the desktop. The most obvious effect of this
option is that it swaps the positions of the monitor images.
Note: This option is also available as the Primary Display option on the pop-
Force detection of a monitor. . If this option appears on your nView Display
Mode panel, click to check it only if you have a monitor connected to the
secondary display connector that is not being detected. This is useful for older
monitors or monitors with BNC connectors.

Clone Mode

Note: Clone Mode does not work if you have only one display device attached.
In Clone mode, two monitors display identical images, which is useful for
presentations. A presenter may use the smaller monitor on the podium, while a
projector monitor reflects the presentation to the audience.
The example in this section starts with the analog display (CRT) as the primary
display and TV or digital display as the secondary display.
75
up menu that appears when you right click the monitor image on the
nView Display Mode panel in Clone and Span modes.
n V i e w D i s p l a y M o d e B a s i c s
N V I D I A C o r p o r a t i o n