Enabling Nview Span/Clone Modes: Windows Xp; Figure 5.26 Disabling Dualview Mode: Windows Xp - Nvidia P128 - Quadro FX2000 Dual Graphic Card 8x 128MB Model OEM User Manual

C h a p t e r 5

Enabling nView Span/Clone Modes: Windows XP

Note: Under Windows XP, you do not need to restart your computer to switch
When you are in Windows XP Span or Clone mode, your Windows Display
Properties Settings panel shows at least "two" monitor images, unlike Windows
2000, which shows only one monitor image.
To disable Dualview mode and, therefore, make nView Span and Clone modes
accessible, follow these steps:
Open the Windows Display Properties Settings panel.
1
Right click the monitor image 2 and click Attached so that the option
2
becomes unchecked.
Click Apply
3
nView Span and Clone modes, only one monitor needs to be enabled on the
Display Settings panel.)
Be sure to click the display image 1 so that it is the selected display.
4
Figure 5.26
Click Advanced to display the NVIDIA GPU tab shown in
5
Click the NVIDIA GPU tab to display the nView Display Mode option in
6
the Media Center menu, as shown in
57
U s i n g n V i e w M u l t i - D i s p l a y M o d e s : D u a l v i e w v s . S p a n / C l o n e
between nView Span/Clone Mode and Dualview mode.
(Figure 5.26). This turns off your secondary display. (To access
Disabling Dualview Mode: Windows XP
Figure 5.28.
N V I D I A C o r p o r a t i o n
Figure 5.27.