Delta UNISAW 34-806 Instruction Manual page 11

422-04-651-0064 - 06-20-05.qxd
A
3. To check the alignment, remove the screw and
fastener plate (C) Fig. 13. Use a straight edge (D) Fig.
14 to see if the splitter bracket (A) is aligned with the
inside blade flange (B). Check both the top and
bottom of bracket (A) with the top and bottom of
flange (B).
4. To adjust, loosen the two screws (F) Fig. 15, and
adjust splitter bracket (A) until it is aligned with the
inside blade flange (B) Fig. 15. Tighten the two
screws (F). Loosely install the screw and fastener
plate (C), that were removed in STEP 3.
5. Insert the threaded end of the support rod (G) Fig. 16,
through the slot in the rear of the saw and into the
hole in the rear trunnion (H). Fasten the support rod
(G) to the trunnion with a star washer and hex nut (J)
Fig. 17.
NOTE: Thread a nut (J) Fig. 17, on the threads of the
support rod (G) as much as possible by hand.
6. Use a wrench to hold the hex nut (J) Fig. 17, insert a
small screwdriver (K) through the hole in the end of
the rod (G) Fig. 18, and tighten the rod (G) Fig. 18.
7. Attach the lower bracket (L) Fig. 19 the to rod (G).
Loosely tighten with two 5/16-18x1" hex head bolts(S)
and 5/16" lockwashers from underneath the bracket
(L).
K
Fig. 18
6/20/05 1:42 PM Page 11
D
B
Fig. 14
G
A
F
H G
Fig. 16
Fig. 17
L
S
11
Fig. 15
J
G
Fig. 19