Kenwood TK 3230 - FreeTalk XLS UHF Instruction Manual page 39

■ ptt id
The transceiver can send a PTT ID signal when pressing
the PTT switch (beginning of transmission) or when
pressing and releasing (beginning of transmission and end
of transmission) the PTT switch.
 With the transceiver power OFF, press and hold the
MENU key while turning the transceiver power ON (for
1 second).
 Press the
 Press the MENU key then press
"Pt-oF" (PTT ID is off), "Pt-bo" (send your own PTT ID at
the beginning of transmission), or "Pt-LI" (send the list
PTT ID at the beginning and end of transmission).
 Press the MENU key to confirm the selection.
 Press the PTT, MON, or CAL key to exit Setting Mode.
■ ptt id S
ide
When the PTT switch is pressed and/or released, a tone
will sound through your own speaker when the PTT ID is
transmitted.
To turn the PTT ID Side Tone on or off:
 With the transceiver power OFF, press and hold the
MENU key while turning the transceiver power ON (for
1 second).
0
or key to select "Pt".
t
one
or to select