Delta Unisaw 36-841 Instruction Manual page 11

K
6. Using a wrench to hold the hex nut (J) Fig. 16, tight-
en rod (G) Fig. 17, with a small screwdriver (K) or similar
device through the hole in the end of the rod as shown.
7. Assemble lower bracket (L) Fig. 18, to rod (G) and
loosely tighten with two one-inch long hex head screws
(S) and lockwashers from underneath bracket (L).
8. Assemble upper splitter bracket (M) Fig. 19, to lower
bracket (L) using one-inch long hex head screw (N) with
lockwasher and flat washer. NOTE: Do not tighten screw
(N) at this time.
9. Insert the front end of splitter (P) Fig. 20, inside the
splitter mounting bracket behind splitter fastener plate
and screw (C). Push splitter down as far as possible,
making certain the bottom edge of splitter (P) is parallel
with the table surface. Tighten screw (C). Fasten splitter
and blade guard assembly (P) Fig. 21, to bracket (M)
using one-inch long screw (V) and flat washer.
10. IMPORTANT: The splitter (P) Fig. 22, features a notch
(W) cut into the top edge. Simply raise the front of the
clear blade guard (P) Fig. 22, until the rear edge of the
guard slips into notch (W) of the splitter. This notch
enables the blade guard to stay in the raised position and
makes changing blades easier.
P
M
V
G
Fig. 17
Fig. 21
N
P
C
W
P
11
G
L
S
Fig. 18
M
L
Fig. 19
Fig. 20
Fig. 22