Recommended Accessories - Craftsman 21239 - 12 in. Sliding Compound Miter Saw Operator's Manual

RECOMMENDED ACCESSORIES
,_ WARNING i
• Use only accessories recommended for
this miter saw. Follow instructions that
accompany accessories. Use of improper
accessories may cause hazards.
• The use of any cutting tool except 12 in.
saw blades which meet the requirements
under recommended accessories is
prohibited. Do not use accessories such
as shaper cutters or dado sets. Ferrous
metal cutting and the use of abrasive
wheels is prohibited.
• Do not attempt to modify this tool or
create accessories not recommended for
use with this tool. Any such alteration or
modification is misuse and could result in
a hazardous condition leading to possible
serious injury.
ACCESSORIES
Visit your Sears Hardware Department or see the
Sears Power and Hand Tool Catalog to purchase
recommended accessories for this power tool.
i_ WARNING 1
To avoid the risk of personal injury, do not
modify this power tool or use accessories not
recommended by Sears.
[,A WARNING]
Read warnings and conditions on your
CARBIDE TIPPED SAW BLADE. Do not
operate the saw without the proper saw
blade guard in place. Carbide is a very hard
but brittle material. Care should be taken
while mounting, using, and storing carbide
tipped blades to prevent accidental damage.
Slight shocks, such as striking the tip while
handling, can seriously damage the blade.
Foreign objects in the workpiece, such as
wire or nails, can also cause tips to crack
or break off. Before using, always visually
examine the blade and tips for bent blade,
cracks, breakage, missing or loose tips,
or other damage. Do not use if damage is
suspected. Failure to heed safety instructions
and warnings can result in serious bodily
injury.
Supplied Not supplied
Blade Wrench Adjustable Wrench
Hex Key
Combination Square
Phillips Screwdriver
Slotted Screwdriver
COMBINATION SQUARE MUST BE TRUE
Should not gap or overlap when square is flipped
over (see dotted figure).
Straight edge or
a 3/4 in. board,
Draw light line on board this edge must be
along this edge. perfectly straight.
Should not gap or overlap when
square flipped over
(see dotted figure).