Table of Contents
Advertisement
Configure or use any of the following:
•
Config File backup/restore
•
PC Database
•
Remote Admin
•
Routing (RIP and static Routing)
•
Upgrade Firmware
•
UPnP
Configuration Program
The TW100-BRV204 contains an HTTP server. This enables you to connect to it, and config-
ure it, using your Web Browser. Your Browser must support JavaScript. The configuration
program has been tested on the following browsers:
•
Netscape V4.08 or later
•
Internet Explorer V4 or later
Preparation
Before attempting to configure the TW100-BRV204, please ensure that:
•
Your PC can establish a physical connection to the TW100-BRV204. The PC and the
TW100-BRV204 must be directly connected (using the Hub ports on the TW100-BRV204)
or on the same LAN segment.
•
The TW100-BRV204 must be installed and powered ON.
•
If the TW100-BRV204 's default IP Address (192.168.0.1) is already used by another
device, the other device must be turned OFF until the TW100-BRV204 is allocated a new
IP Address during configuration.
Using UPnP
If your Windows system supports UPnP, an icon for the TW100-BRV204 will appear in the
system tray, notifying you that a new network device has been found, and offering to create a
new desktop shortcut to the newly-discovered device.
•
Unless you intend to change the IP Address of the TW100-BRV204, you can accept the
desktop shortcut.
•
Whether you accept the desktop shortcut or not, you can always find UPnP devices in My
Network Places (previously called Network Neighborhood).
•
Double - click the icon for the TW100-BRV204 (either on the Desktop, or in My Network
Places) to start the configuration. Refer to the following section Setup Wizard for details
of the initial configuration process.
Where use of a certain feature requires that
PCs or other LAN devices be configured, this
is also explained in the relevant chapter.
Chapter 9:
Other Features and Settings
Setup
9
Advertisement
Table of Contents
