Check The Leds - TRENDnet TW100-BRV204 - VPN Firewall Router User Manual

3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the TW100-BRV204. Use the ca-
ble supplied with your DSL/Cable modem. If no cable was supplied, use a standard cable.
4. Power Up
•
Power on the Cable or DSL modem.
•
Connect the supplied power adapter to the TW100-BRV204 and power up.
Use only the power adapter provided. Using a different one may cause hardware damage

5. Check the LEDs

•
The Power LED should be ON.
•
The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
•
For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is
also ON.)
•
The WAN LED should be ON.
For more information, refer to Front-mounted LEDs in Chapter 1.
Installation
7