Table of Contents
Advertisement
Disconnect
Clear Log
Refresh
Connection Status - Telstra Big Pond
An example screen is shown below.
Data - Telstra Big Pond Screen
Connection
Physical Address
IP Address
Connection Status
If connected to your ISP, hang up the connection.
Delete all data currently in the Log. This will make it easier to read
new messages.
Update the data on screen.
Figure 24: Telstra Big Pond Status Screen
The hardware address of this device, as seen by remote devices.
(This is different to the hardware address seen by devices on the
local LAN.)
The IP Address of this device, as seen by Internet users. This
address is allocated by your ISP (Internet Service Provider).
This indicates whether or not the connection is currently estab-
lished.
•
If the connection does not exist, the "Connect" button can be
used to establish a connection.
•
If the connection currently exists, the "Disconnect" button can
be used to break the connection.
•
Normally, it is not necessary to use the Connect and Discon-
nect buttons unless the setting "Connect automatically, as
required" is disabled.
Operation and Status
37
Advertisement
Table of Contents
