Chevrolet EQUINOX GMC TERRAIN NAVIGATION SYSTEM - 2011 Introduction Manual page 43

The RSE system transmits the
audio signal to the wireless
headphones if an audio signal is
available. See Headphones earlier
in this section for more information.
The front seat passengers are able
to listen to playback from the A/V
jacks through the vehicle speakers
by selecting Rear A/V as the source
on the radio.
Video Screens
The video screens are located in the
back of the driver and front
passenger seats.
To use the video screen:
1. Push the release button located
on the seatback console.
2. Move the screen to the desired
viewing position.
Push the video screen down into its
locked position when it is not in use,
the screen turns off automatically.
Only the left RSE seatback console
contains the infrared transmitters for
the wireless headphones, they may
be visible as eight illuminated LEDs.
These LEDs are not on the right
video screen. Both seatback
Infotainment System
consoles contain an infrared
receiver for the remote control. They
are located at the top of each
console.
Avoid directly touching
the video screen, as damage may
occur. See Cleaning the Video
Screen later in this section for
more information.
Video Screen Input Jack
Each video screen is equipped with
a video input jack to allow video
cables to be connected from an
auxiliary device such as a
camcorder or a video game system.
This signal will override any video
provided by the RSE system; either
the DVD or Auxiliary A/V jack
source. The RSE system must be
on for this input to operate.
43