Chevrolet CAMARO - 2010 Owner's Manual page 266

To replace a taillamp, turn signal,
or stoplamp bulb:
1. Open the trunk. See
.
2. Remove the close out panel
retainers to gain access to the
bulb socket connectors.
3. Turn the bulb socket
counterclockwise to remove it.
4. Pull the old bulb straight out of
the bulb socket.
5. Push the new bulb straight into
the bulb socket until it clicks.
6. Turn the bulb socket clockwise
to reinstall.
To replace one of these bulbs:
1. Unclip the license plate lamp
from the facia opening.
2. Pull the license plate lamp down
through the facia opening.
3. Turn the bulb socket
counterclockwise and pull the
bulb straight out of the lamp
socket.
4. Install the new bulb.
5. Push the bulb straight into the
socket and turn clockwise to
reinstall.
6. Reinstall the license plate lamp
by lifting it through the facia
opening until the clip is in place.