Wireless Lan Advanced Screen; Figure 38 Wireless Lan Advanced; Table 33 Wireless Lan Advanced - ZyXEL Communications P-334WH User Manual

4.5 Wireless LAN Advanced Screen

Click Network > Wireless LAN > Advanced. The screen appears as shown.

Figure 38 Wireless LAN Advanced

The following table describes the labels in this screen.

Table 33 Wireless LAN Advanced

LABEL
Wireless Advanced Setup
RTS/CTS
Threshold
Fragmentation
Threshold
Output Power
802.11 Mode
Apply
Reset
Chapter 4 Wireless LAN
DESCRIPTION
Data with its frame size larger than this value will perform the RTS (Request To
Send)/CTS (Clear To Send) handshake.
If the RTS/CTS value is greater than the Fragmentation Threshold value, then the
RTS/CTS handshake will never occur as data frames will be fragmented before they
reach RTS/CTS size.
Enter a value between 0 and 2432.
It is the maximum data fragment size that can be sent. Enter a value between 256
and 2432.
Set the output power of the ZyXEL Device in this field. If there is a high density of APs
within an area, decrease the output power of the ZyXEL Device to reduce
interference with other APs.
The options are 100%, 80% and 60%.
Select 802.11b to allow only IEEE 802.11b compliant WLAN devices to associate with
the ZyXEL Device.
Select 802.11g to allow only IEEE 802.11g compliant WLAN devices to associate with
the ZyXEL Device.
Select 802.11b/g to allow either IEEE802.11b or IEEE802.11g compliant WLAN
devices to associate with the ZyXEL Device. The transmission rate of your ZyXEL
Device might be reduced.
Click Apply to save your changes back to the ZyXEL Device.
Click Reset to reload the previous configuration for this screen.
P-334WH User's Guide
81