Table of Contents
Advertisement
HP SureStore DAT
Installing an "eU" Model Drive (external for Unix)
Step 4: Connect the Power Cable
An external HP SureStore DAT drive will operate using any voltage in the
range 100–240 volts (50-60 Hz). No adjustment is needed. To connect your
drive to the power supply, proceed as follows:
1 Push the DIN plug on the power supply's cable securely into the socket on
the rear panel of the drive, as shown in figure 2.4.
2 Plug the power cable securely into the power supply.
3 Power up the drive by plugging the other end of the power cable into the
power outlet.
The tape drive will run its self-test, which takes about 5 seconds. At the end
of the self-test, both front panel lights should be off. Read more about the
self-test and front panel lights in the electronic User's Guide on the
HP SureStore Tape CD-ROM.
4 Switch on the computer.
Figure 2.4 Connecting the power supply
Power supply
Power cable
Note Always power up the drive before powering up the computer, otherwise
the computer may not recognize the drive.
2-8
DIN plug
Hide quick links:
Advertisement
Table of Contents
