Table of Contents
Advertisement
3 Attach the other end of the SCSI cable to one of the SCSI connectors on the
rear panel of the tape drive. (See figure 2.3.) Snap both of the retaining
clips over the connector to secure it firmly in place.
Figure 2.3 Rear panel of an external HP SureStore DAT drive
4 Make sure that the terminator is firmly attached to the drive's other SCSI
connector.
If you want to attach additional devices to the SCSI bus after the tape
drive, you will need to remove the SCSI terminator and attach the next
device to this SCSI connector. Make sure that you attach the terminator to
the last device in the chain.
Note Write the model name, product number, serial number, and SCSI ID of
your drive in the front of this guide for future reference. The model name
is on the front of the drive and the product and serial numbers are on a
label on the bottom of the drive.
Installing an "eU" Model Drive (external for Unix)
HP SureStore DAT
SCSI connector 1
SCSI connector 2
with terminator
fitted
Power socket
2-7
Hide quick links:
Advertisement
Table of Contents
