Skoda RADIO NAVIGATION SYSTEM CRUISE - FOR OCTAVIA Manual page 16

14 Navigation
•
Entries in square brackets [ ... ] cannot be selected or edited at present because
e.°g all of the necessary data have not yet been entered. First of all a country and a
city must be selected when e.°g entering an address before the street can be
entered.
Tour plan
Call up tour plan
– Press the button .
NAV
– If the tour plan is not displayed, press the function key
select the menu point route with stopover destinations.
A
and select the menu point insert new
– Press the button
1
destination. If a destination has already been displayed, you must
decide if this destination should be part of your tour. Otherwise you
must delete this destination.
– In the menu point insert new destination you can select the type of
destination entry and the destination.
– An existing address in the tour plan can be accepted with the menu
point accept (e.°g for a round trip as a starting and finishing point).
– The newly entered destination is included in your tour with the menu
point end entry.
– You can determine the position where the newly entered destination
shall be stored using the button
order of the destinations of the tour and if a newly entered destination
shall be added to the tour as a stopover destination or a main travel
destination.
During a current route guidance, you can insert additional stopover destinations in
your tour (maximum six per tour).
and
ROUTE
A
. The position determines the
1
Edit a tour or drive to a determined stopover destination
If you have selected a destination from the tour plan, you can call up the following
functions:
•
Change - e.°g change the street name;
•
Move - change the order of the destinations. If you move a stopover destina-
tion to the end of your tour, it becomes automatically a destination and the original
destination becomes the last stopover destination;
•
DELETE - deletes the destination from the tour;
•
Starting off now - starts the route guidance directly to this destination. Inter-
mediate destinations are ignored. If this is a stopover destination, the tour is
continued at this point after reaching the stopover destination.
Route setups
– Press the button and the function key
NAV
Route with stopover destinations
If this function has not been switched on, several destinations can be entered.
Route list
During a current route guidance, you can look up all the stretches of the route for
the present tour up to the next destination or stopover destination.
Fig. 7 Route setups
.
ROUTE